directRT 2012 parallel port
directRT 2012 parallel port
If the computer running windows 7 has a built in parallel port I can successfully run the I/O ttl test at address 888.
However that computer is being replaced with a win 7 computer without a built in parallel port. A pci express card is installed and the driver is oxford semiconductor. The resource settings which cannot be changed have
I/O range D010-D017
I/O range D000-D003
I have converted the hex to decimal and typed that into the port field for the ttl test and am unsuccessful in having the port change state.
When the computer is booting a signal is sent to the parallel port because my status light blinks on then turns off.
When I open the ttl test tool, the port address drop down shows:
lpt1 absent
lpt2 absent
-12272 [lpt3: D010H]
I converted the hex number incorrectly. Address 53264 decimal works.
If the computer running windows 7 has a built in parallel port I can successfully run the I/O ttl test at address 888.
However that computer is being replaced with a win 7 computer without a built in parallel port. A pci express card is installed and the driver is oxford semiconductor. The resource settings which cannot be changed have
I/O range D010-D017
I/O range D000-D003
I have converted the hex to decimal and typed that into the port field for the ttl test and am unsuccessful in having the port change state.
When the computer is booting a signal is sent to the parallel port because my status light blinks on then turns off.
When I open the ttl test tool, the port address drop down shows:
lpt1 absent
lpt2 absent
-12272 [lpt3: D010H]
I converted the hex number incorrectly. Address 53264 decimal works.
Hi ARL,
Thanks for taking a moment to share. It sounds like things are working properly now.
Just for future reference, would you mind posting the make / model number of your parallel port card, and perhaps a link to the place you purchased it?
John
